CRAIG'S
ROBOTICS &
ANIMATRONICS SITE
Haunting Creation, Consulting, Prop Fabrication and
Animatronics Hardware and Software
**Solutions, Consulting & Products for the Haunting Enthusiast**
|
CRAIG'S ROBOTICS & ANIMATRONICS SITE Haunting Creation, Consulting, Prop Fabrication and Animatronics Hardware and Software **Solutions, Consulting & Products for the Haunting Enthusiast**
|
|
Prop-Mover Mechanisms For Sale Pneumatic, Animatronic and other Prop Supplies
|
This animation has opening and closing sliding front doors, a lid in the top of the table which opens and a corpseless head which springs out of the inside of the table. When a pressure mat is activated, a PLC microprocessor starts the animation by thrashing open and closed two sliding doors in the front of the table, then the table lid opens and a head lunges out screaming. The head then retracts and the lid closes, but the sliding doors continue to animate for a few seconds later. The show resets instantly waiting for the next victim. Requires 50 PSI air compressor, 120V. All self-contained and microprocessor controlled, pre-programmed 30 second show. Click on Thumbnails for larger view....
|
Last modified: April 23, 2014All images, plans and design graphics are the sole property of Craig's Robotics & Animatronics, and are protected by copyright law. Under no circumstances should any items be reproduced or copied without written consent from Craig's Robotics & Animatronics. Copyright 1998- 2014 Craig's Robotics & Animatronics |
